AVS Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi,

I have a Philips 32 LCD (32pfl5332d/37) I was going to make a bracket for a wall mount but I'm curious about the attachment to the TV. The six holes at the rear of the set appear to be only attached to the plastic back and not to the chassis are these the holes I should be using? And if anybody know what size these screws are that would be helpful. I think they're metric, closest I can get #6x32.

All help appreciated.

Mike
 

· Registered
Joined
·
586 Posts
There should be only 4 holes, and yes, the Bolts should be 6 mm.

I looked at your manual and it doesn't state anything about mounting, but I'm pretty sure it's Vesa 200 compatiple like so many that size.

The holes in the backpanel should actually go through and attach to the Chassis.


Vesa Standards:

http://www.ergomart.com/VESA/VESA_75_100_200_700PX.htm


cheers!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top