AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
Why I decided to tweak my ECP 3500 I don't know.


Anyway, I pull off the cover and noticed that the face of the crt had a few drops of water on it. I suspect it is coming from the crt (green)... it is only a couple of drops..what do I do now. Can I seal it with silicon or something?


another problem is that my red crt sometimes shuts itself down for a second or two and then pops back on...it happens intermittently. I noticed that when I was focusing it that sometimes the red grid disappears and pops back on, sometime some of the lines disappear..or it just fades a bit... could this be a bad dallas chip?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top