AVS Forum banner
Status
Not open for further replies.
1 - 10 of 10 Posts

· Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I am just curios if anybody has compared these two projectors in detail.


I know that the lumen is higher on the 6210 and that the noise id lowerer compared to 6200 but what else?



1. -Have they fixed the shortage of connectors, are there more connectors on 6210? Separate Component inputs?


2. -Have they fixed the complaints about that the White segment of the color wheel cannot be turned off on 6200?


3. -Have they fixed the minor Issues on HDTV 1080i?


4. -Have they improved on the poor interlacer/scaler that 6200 uses?



What other differences of significance are there?


..there must be a few improvements, since this projector is at least $300 more, or am I wrong?
 

· Registered
Joined
·
63 Posts
Removed...I didn't read the original post...thought it was the 6200 vs the 6100.


Hey, it was early in the morning & I didn't have my coffee by then! :D
 

· Registered
Joined
·
350 Posts
Quote:
Originally posted by MartinK
This page has the 6110/6210 manual (click on 6110 they are the same)

http://www.benq.com/drivers/manuals/projectors.html


The manual shows the unit now has two analog inputs, and has gained USB and audio connectors.


The USB enables you to flip PPT slides via the projector's remote.
The other D-Sub is an output so you can run a monitor off the same signal for presentations.
 
1 - 10 of 10 Posts
Status
Not open for further replies.
Top