AVS Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
459 Posts
Discussion Starter · #1 ·
The header says it all... I need the cable that goes between the switcher and the projector... does anyone know of a place to get these? Price?


Thank you,

Sean
 

·
Registered
Joined
·
267 Posts
Check with Curt Palme, I bought a cable from him that was supposedto be 14 pin, and turned out to be 10 pin. I returned it.
 

·
Registered
Joined
·
3,901 Posts
You could also watch ebay, I've seen a couple sell there. And try www.markertek.com , I think they carried it at one time, but I'm not sure. VDC might have some kicking around. I think the connector is an industry standard one, if you have the pinouts, you could also make one. The cable only has RGBS and a control line in it(I've cut the end off one) so only 5 of the pins are used. I think you coudl even determine the pinout by tracing the leads in the switche itself.
 

·
Registered
Joined
·
2,861 Posts
It's pretty easy to trace the leads on the input card itself as well...
 

·
Registered
Joined
·
459 Posts
Discussion Starter · #6 ·
I was just thinking... now that I have an IR remote, I really don't need to do this anymore! I wonder if the switcher boosts the signal... All if the extra boards in the chain can't be too good...


Sean
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top