AVS Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
Does anyone know where I might be able to find the codes to control this set through the serial port? Any help would be greatly appreciated!
 

·
Registered
Joined
·
3,679 Posts
I believe three statements have been reported by reputable forum members who were quoting their reliable Samsung Contacts:


1. Port is for uploading firmware only - NO CONTROL

2. Port is for control only - NO FIRMWARE UPGRADES

3. (I can't repeat, but it's not what you want)


I think someone should hookup a serial cable to it and HyperTerm and see if anything spits out of it on power up, etc.



Ken
 

·
Registered
Joined
·
4,484 Posts
Ken, I nominate you in doing so :)
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #4 ·
Surely there is a resource that identifies the serial codes used on this set. I can't imagine including a serial connection and not enabling it for control of the set. On that note, I am also curious if there are discrete IR codes for power on/off and source selection. Does anyone know this info or know where I can find it? I interested in controling this set with my HTPC and Girder, but I cannot find the info to do so.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top