I just buy Quadscan Elite, I'm not yet connect QS to Vidikron D-2200.(QS still in shipping journey),
I'm still confused about the QS sync configurations.
Which type sync configurations should I use for connecting QS to D-2200?
RGB/HV(5 wire), RGB/S(4 wire), or RGB"sync on green"(3 wire) configurations?
Here is D-2200 spec for RGB input :
R.G.B. : 0.7 Vp-p (1.0 Vp-p at G.SYNC signal), 75 ohm
HD/SYNC and VD : TTL high impedance, automatic plus/minus
polarity compatible
Thank you in advance for any advice.
I'm still confused about the QS sync configurations.
Which type sync configurations should I use for connecting QS to D-2200?
RGB/HV(5 wire), RGB/S(4 wire), or RGB"sync on green"(3 wire) configurations?
Here is D-2200 spec for RGB input :
R.G.B. : 0.7 Vp-p (1.0 Vp-p at G.SYNC signal), 75 ohm
HD/SYNC and VD : TTL high impedance, automatic plus/minus
polarity compatible
Thank you in advance for any advice.