AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hi,

I'm more of a lurker than a poster here, as my AV knowledge is limited and specific. So in this case I'm reaching out with broad strokes and hoping for specific direction.

I am completing my first home and part of my structured wiring includes a couple "satellite" speakers

Audio Hardware:

Reciever: Onkyo HT-S5100
  • 190 W (4 ohms)
  • 130 W (8 ohms)
  • THD 0.9 %
Primary Speakers: Included

Secondary Speakers:

Living Room (Large/14' Vault/Long by Tall): Dual (L/R) Leviton AEC65 by JLB
  • Freq Response: 40Hz-20kHZ
  • Sensitivy: 88dB
  • Power Handling: 80 Watts
  • Imp: 8 Ohms
Bedroom: (Medium/9'/Cube): Single, Dual-Channel Leviton AEM65 by JBL
  • Freq Response: 40Hz-20kHZ
  • Sensitivy: 88dB
  • Power Handling: 100 Watts
  • Imp: 8 Ohms
Bath: (Medium/9'/Cube): Single, Dual-Channel Leviton AEM65 by JBL
  • Freq Response: 40Hz-20kHZ
  • Sensitivy: 88dB
  • Power Handling: 100 Watts
  • Imp: 8 Ohms
Outdoor: (Open/12'/Outdoor) Dual, L/R Yamaha NS-AW150
  • Freq Response: 55 Hz - 40 kHz
  • Sensitivy: 85dB
  • Power Handling: 120 Watts
  • Imp: 6 Ohms

Controls:

The whole-home speakers will be powered by an amp (therein lies my question), connected to an impedance matched distribution module, connected to independent volume controls.

Living Room - one control
Bathroom/Bedroom - one control
Outdoor - one control

All that information said; i have no idea what amp to buy. I have a relative budget as this system is pretty simple and my receiver should exemplify that.

Any suggestions would help.

taylorjes

PS - Amazon Prime is my friend
 
1 - 1 of 1 Posts
Top