AVS Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter #1
I currently am using a sony 1271 and I notice that the convergence is unstable. I will go in the main menu section to adjust the convergence and as I adjust I notice the other colours bounce and I can never converge the unit. Whats wrong with this unit? Any suggestions?
 

·
Registered
Joined
·
1,259 Posts
If you are adjusting convergence in registration block four, make all adjustments with no input. In other words, don't put conflicting settings between the pj's internal signal, and settings with an external signal in the same registration block.


I did this by mistake once, ( my dvd player outputs a sync signal even when off!) and had to restore convergence settings to factory default and re-converge reg block 4 with no input to correct problem.
 

·
Registered
Joined
·
54 Posts
Also, my 1270 had a very strange downward rolling appearance to the image.. i changed power cords and plug location on my wall.. and it works fine now.. very stable.. but before it was weird.. maybe that helps.


Aaron
 

·
Registered
Joined
·
8,079 Posts
Ground loop probably Aaron.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top