AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
3,347 Posts
Discussion Starter · #1 ·
I have 2 sets of main speakers connected to my Yamaha RX-V3300, one set is for HT/ multi channel use and the other is for stereo use.


When I set speakers 'b' to 'main' I get sound thru the 5 surround speakers which would be the 'a' main speakers wether 6 channel input is on or off and both speakers A and B set to off.... sound is bleeding thru, oddly enough I dont get any sound out of the 'b' speakers.


Now if I set speakers 'b' to 'zone 2' , and turn off speakers a and b then I get no bleed thru sound with 6 channel input on or off, I have to turn on speakers A to get the sound.


What in the heck is going on here?


I hope I explained it well enough, if not ask away.
 

·
Banned
Joined
·
84 Posts
Try changing the setup for speaker B in the main setup where it has option whether speaker B are placed in same room or other room.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top