AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter · #1 ·
Looking at the spec sheet for the panasonic 711xu, I see that it has 2 vga inputs. What is the correct way to connect a prog scan dvd player to this pj?


1) a simple 15pin-->3 rca breakout cable


2) component cable from dvd --> transcoder then: 15pin--> 15pin vga cable --> to 711xu


if #2 is best what does the transcoder do ?
 

·
Registered
Joined
·
660 Posts
Yep...first option is better.


By "transcoder" do you mean line doubler or scaler, perhaps? If it's ONLY transcoding a Component (Y, Pb/Cb, Pr/Cr) signal to a VESA standard computer monitor resolution, it's an unecessary additional electronic step.


Even most line doublers will not improve on the picture-quality vs. component-p (progressive) output straight from the DVD player.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top