AVS Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I'm considering a dual opposed AV15H (DVC 4 ohm drivers) project. While reviewing the wiring diagram for parallel connection, I noticed the pos and neg wires split and go to each driver. Is it best to run two wires from each binding post or split the wire? I'm planning on a 4 ohm final load.
 

·
Registered
Joined
·
21,345 Posts
those speakers are available in 4 and 8 ohm.


you probably need the 8 ohm, as those in parallel will give a 4 ohm load.


when you call john j. to order, he will help you.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top