AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter · #1 ·
I just received my X1 and I have a question. I have a question about the remote. It seems that the remote has to be pointing directly at the front of the projector to work. Since I will be ceiling mounting the projector and it will be in front of my seating position, I am not sure how much of a problem this will be.

Does anyone else have this issue, and if so how did you resolve it.


Dave
 

·
Registered
Joined
·
135 Posts
I've had my X1 since June...


It's mounted just about directly above my seating location. No problems with the remote not working. I just point it at the screen (DIY Parkland) and the signal bounces back to the X1's IR receiver just fine.


Hope that helps.


Dan
 

·
Registered
Joined
·
105 Posts
Discussion Starter · #4 ·
Thanks, I have it on a coffee table now and the signal was not bouncing of the front wall and hitting the projector. I will try it again when it is mounted and I have a screen.


Dave
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top