AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter · #1 ·
Trying to learn XG & HTPC all at once is taxing my patience, but I have perused tons of info here and ALL of the XG posts, but still need a tad more help before I can turn the corner.


I have installed Powerstrip on my HTPC


I am getting a signal out of the Ti4200 video card , 1440 x 960P x 72

but I just get that scrolling display with the high pitched squeal on my XG110 even on 1024 x 768 or 800 x 600.


Yes, I unplug the breakout cable real fast when I get that, but I cannot seem to get it to, what's the word ?, sync ? I have tried all combos of +/- sync in powerstrip to no avail.


After reading the tech manual, it seems to me that it should 'sync' (if that's the correct term) correctly without any intervention, but then I have to set up the 'signal entry' to carry over some of the setup parms - have I got this right ?


Can someone explain this 'Signal Entry' thing to me ?


I am able to get an input to the S-video from my Tivo to display very nicely.

I had an XP window up in RGB yesterday for awhile, but I'll be darned if I know how to get it again since I installed Powerstrip.


TIA for any and all help

.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top